Custom trailer fabrication · Kalispell, MT
Custom enclosed trailers, aluminum builds, restoration, and finishing. Laid out on the bench in Kalispell and delivered across the Flathead Valley.
Call (555) 014-2290 / Flathead Valley, northwest Montana
The bench · KalispellAluminum sheet, looms and hand tools laid out on the same steel table every build starts from.
The build process
Every trailer moves through the same five stages on our bench. Nothing gets covered up until the stage underneath it is right — which is why the frame is checked before the skin, and the wiring is tested before the walls close.
Every build starts on the bench. The chassis is laid out, squared corner to corner, and welded true before anything else goes on it. If the frame is off, nothing downstream can be made right.
Aluminum goes on flat and even, fastened on a consistent line. Fastener spacing is set by hand and checked by eye down the length of the trailer, because the skin is the part everyone sees first.
Doors are hung, shimmed, and cycled until they close clean and seal without a fight. Hardware is adjusted on the bench, not in your driveway.
Circuits are run in looms, kept clear of sharp edges, and tested before the interior closes up. Access points are placed where they can still be reached later on.
Trim, sealant, hardware, and a clean interior. The last ten percent is the part you actually touch every time you load up, so it gets the same attention as the welds.
Restoration & proof
Some trailers come in with good bones and tired skin. We strip them back, look honestly at the frame, and rebuild from there — same sequence, same standards, second life.
Same five stages as a new build — only the first one takes longer, because an older frame has to be inspected rather than trusted.
Services
Custom enclosed trailers, aluminum builds, restoration and finishing — all handled in the same shop, by the same hands that weld the frame.
Built to the job you actually do. Chassis laid out and welded, skinned in aluminum, doors hung, interior finished — from $8,500, quoted to your spec.
Aluminum framing and skin for owners who want less weight behind the truck. Same squared chassis, same consistent fastener lines, hung panel by panel.
Strip, inspect, repair, re-skin, re-wire. A tired trailer with good bones gets the same sequence as a new build, starting at the frame and working outward.
Trim, sealant, hardware, lighting and interior work — on a build of ours or a trailer you already own. The details are what you live with.
Service area
The shop sits in Kalispell and the work travels out from there — up the valley, around the lake, and over to the canyon. If you are in northwest Montana, you are in range.
Contact the shop
Describe the job and we will talk through frame, skin, doors and finish before a single cut is made. Most builds begin as a conversation on the phone.
(555) 014-2290Send the details and we will get back to you about your build.