Enter a part number.
Leave with a quote.

Machined bushings, flight-control fittings and seals, turned and finished to the print you send — with AS9100 inspection and kitting on the same order.

01Bushings and fittings, turned and milled to your print.
02Seals and hardware, matched to the gland you specify.
03AS9100 inspection, and kits packed to the bill of material.

Index

Stock and made-to-order, in one place.

Five families cover most of what leaves the floor. Send a part number with the drawing revision and we return availability and a quote.

01
Machined bushings Flanged, plain and shouldered, turned to print.
02
Flight-control fittings Rod ends, bellcranks and brackets for control runs.
03
Seals Standard and high-temperature profiles, matched to the gland.
04
AS9100 inspection First article through final, with the paperwork to match.
05
Kitting Parts, seals and hardware packed to the bill of material.

Request a quote

Index preview

Part families we run most often.

Availability and lead time are confirmed against the part number and revision you send.

Part family	Material / form	Index status	Quote
Bushing, flanged BSH · FLG · BRZ	Bronze · flanged	Stock	Quote →
Bushing, plain sleeve BSH · SLV · 17-4	17-4 PH · plain	Stock	Quote →
Fitting, rod end FIT · RDE · 15-5	15-5 PH · rod end	Made to order	Quote →
Fitting, bellcrank FIT · BLK · 7075	7075-T6 · per print	Quote required	Quote →
Seal, high-temperature SEL · AS568 · FKM	AS568 series · FKM	Stock	Quote →
Kit, assembly pack KIT · BOM · SER	Per bill of material	Made to order	Quote →

Representative families only. Send the part number and revision for availability and lead time.

Capabilities

What leaves the floor.

Parts move through one bench and one routing sheet. Bushings, fittings and seals are finished, checked and packed before anything is released.

Machined bushings staged on a bench for inspection — 01 Turned bushings staged before inspection.

Verification

Checked against the drawing revision

First article, in-process checks and final inspection are recorded, and the records travel with the lot.

Kitting

Packed to the bill of material

Parts, seals and hardware are counted, serialized where the build calls for it, and packed as one kit.

Flight-control fitting measured on a granite surface plate — 02 Critical features checked on the plate before release.

Process

From part number to release.

Three steps, and the print is the only thing we quote from.

01
Search the index

Type the part number or pick a family. The index shows what is held and what has to be made.
02
Send the print

Add the drawing, revision and material callout. The quote is built from the print, not from a guess.
03
Confirm and release

Availability, inspection route and paperwork are confirmed before the lot goes to the floor.

RFQ

Send the requirement.

Part number, quantity and certification. Revision, material and finish go in the notes.

Enter a part number.Leave with a quote.